6/8/2023 0 Comments 41 af filter cartridge![]() A positive click should be felt to indicate that the filter is firmly in position.Shipping Policy Online orders of $250 or more, and offline orders of $1000 or more, will ship for FREE within the contiguous United States-some exceptions apply. With the filter correctly orientated and re-positioned carefully over the flow circuit sensors, gently push the filter assembly into the Sensor Cartridge. To replace the filter cartridge within the Sensor cartridge sub-assembly, ensure that the filter cartridge is correctly orientated. Inspect, Service or replace the filter cartridge as required. Be careful not to damage the exposed flow circuit sensors. Gently pull the filter cartridge assembly away from the bottom of the Sensor cartridge. Having removed the Sensor cartridge from the body of the ECO detector as instructed above: When refitting the cartridge in the ECO detector body, remember that the two parts are keyed such that they cannot be fitted in the incorrect orientation without excessive use of force. If the Cartridge is being replaced, ensure that the correct part is being fitted in its place. The cartridge can now be inspected, serviced and or replaced as is necessary. Support the body of the ECO Detector with the other hand whilst carefully pulling the sensor cartridge. Place index finger and thumb on each end of the sensor cartridge in the textured positions provided. Lay these to the side of the Detector body to provide access to the Sensor Cartridge. This will reveal the ECO power and communications cabling. Isolate the power connection to the ECO Detector. ![]() To remove the Sensor Cartridge sub-assembly from the ECO Detector body, follow these instructions ( Caution - Removing the lid of the Sensor cartridge sub-assembly will void the product warranty): In particularly dirty environments the filter cartridge must be inspected regularly. This will reduce the ECO’s ability to detect a threat. Pre-calibrated sensor cartridges are easily replaced in the field and make converting to different gas sensors or replacing sensors a simple task.ĭepending on site conditions the ECO filter cartridge can become contaminated and eventually block. Each ECO gas detector can house up to two gas sensors, and additional detectors can be added easily to the pipe network to monitor more gases if required. VESDA ECO uses an existing or new aspirating pipe network to actively monitor for gas escapes and build-ups. VESDA ECO was developed to provide cost-effective gas detection and environmental monitoring in numerous applications and environments. In many facilities, unseen dangers exist from gases and other hazardous substances that can cause enormous damage and loss of life. VESDA ECO provides early warning of toxic, oxygen and flammable gas hazards to protect personnel and property whilst ensuring business continuity. Vesda Xtralis ECO-SC-41 ECO Sensor Cartridge Carbon Monoxide (CO) 0-500PPMĪn ECO detector replacement cartridge which has been calibrated to detect Carbon Monoxide (CO) ranging between 0-500 PPM. Please see EOL Notice 2020 document for more information. Please Note: The ECO range is now unavailable, and the direct replacement is the VESDA Sensepoint XCL range.
0 Comments
Leave a Reply. |